Hi,I am having some issues with my VDR (version 1.1)
In the beggining I tried to run the Integrity Check and got this error:
Integrity check failed for the restore point created on (date) (time) for (VM name)
Backup Set (destination name) will be locked until the restore point with errors are deleted and integrity check succeeds.
I had marked for delete the damaged restore point and tried to run the integrity check again, but I had the same issue (and the damaged restore point was still there)
So, I oppened the VDR console, stopped the DataRecovery service, deleted the configuration file, started the service, mounted the datastore, recreated the backup job and tried to run the integrity check again. It failed again.
The message below also appears in the VDR log:
Trouble reading from destination volume, error -2241 ( Destination index invalid/damaged)
Backup Set (destination name) will be locked until the restore point with errors are deleted and integrity check succeeds.
After some researches, I read in the KB that I had to power off VDR in order to delete the BackupStore.cat and BackupStore.cat.bak files and start an integrity check again, so the engine would rebuild the catalog and I would be able to run the Integrity Check.
I did it, as they were saying, but the problem persisted.
Looking in the KB again, I´ve found that I had to remove the lock file(_store.lck_), but there isn´t any lock file inside the BackupStore directory.
Conclusion: I can´t backup the VMs because I can´t run neither the Integrity Check (even when I mark the damaged restore point for delete) not the Recatalog.